Table of Contents
People often ask, how often does a Leica rangefinder camera need an alignment?
Let’s find out!
How Often Does a Leica Rangefinder Camera Need an Alignment?
A Leica rangefinder does not need alignment until you drop it. But it would be best if you got it checked after 6 months.
The Leica M6 rangefinder camera has a built-in autofocus system that uses a contrast detector sensor. This works by measuring the light reflected from the subject being photographed.
It then compares this measurement against the stored information about what the lens should focus on. If the two don’t match, it will automatically adjust the lens so that they do.
Note: If you want to know a complete guide and tutorials about rangefinder click HERE.
DIY Rangefinder Adjustment
You can fix this yourself. You need to adjust the focus ring on your lens. Focus on something far away and then move the focus ring until the subject is sharp. Then move the focus ring back to infinity and lock it there. This should hold the patch in place without drifting.
Note: If you want to know How Do I Turn Off a Nikon Laser 600 Rangefinder Buckmasters click HERE.
Horizontal RF Adjustment
To align the RF patch at infinity you need to turn the eccentric screw on the end of the coupling arm. You must be careful not to push against the rangefinder arm.
When adjusting your telescope, make sure to check the alignment of the optics every time you adjust them. You should be able to see the stars when looking straight down the tube. If you can’t, then you may need to adjust the focus.
A screw that holds the roller in place so it doesn’t move when adjusting the rangefinder. This allows you to zero out the rangefinder to accurately evaluate it.
The eccentric pivot adjusts how much the arm moves relative to the shaft rotation so you can adjust the focusing accuracy between infinity to close focus.
Note: If you want to know Sig Rangefinder Binoculars Why Discounted clicks HERE.
How Often Does a Leica Rangefinder Camera Need Alignment?
Vertical RF Alignment
Yes, you can do it yourself! But if you’re using an older model, you’ll need to take it to your local camera shop or repair center to get it done.
Note: If you want to know What Rangefinder Phil Mickelson Use click HERE.
Conclusion
If you have a late-model M4-P or later, you’ll need to use an RF (radio frequency) adjustment tool. To get rid of the Leica red dot logo, you’ll need to remove the lens cap and unscrew the screw underneath it.
We hope that this article was helpful. If you have any queries feel free to reach out in the comments section below.
If you want to know more information about rangefinder click HERE.
