Table of Contents
Crosshairs can get crooked sometimes, in this article we will cover…
How to fix crooked crosshairs on a scope?
Let’s find out!
Expert’s Choice for the Best Scope of February 2023
Our experts tested the popular scopes of the month to find the best one and after a lot of deliberation (read “heated debates”), we have picked this one as our choice for this month.
Quick note: This product’s versatility means it can sometimes be temporarily unavailable due to high demand. We suggest you check it out now to see if you’re eligible for a discount.
How To Fix CrossHairs On A Scope?
You should remember that this is an easy solution, but if you have an expensive scope or one with a great warranty, you may wish to send it in to get repaired.
This method is great if you don’t have the time to send the scope out and wait for it to return if you don’t want to use a warranty on the scope because you’re afraid of losing it, or if you just want to avoid having to send it away.
Keep your glue job clean and there won’t be any need to send it away.
Note: If you want to know tutorials and tips about scopes click HERE.
Unscrew The Eyepiece
First, you want to locate where the eyepiece connects to the scope body. It’s attached by a screw. You’ll need to carefully unscrew it, or else it might break off. Once it’s loose, you can remove it.
Rotate The Reticle
After removing the eyepiece you should see your reticles attached to a little brass ring in the body pieces of the scope. You should then gently rotate this until it’s as level as possible. Windage and elevation knobs may be used as references to make sure your reticle is perfectly straight up and down.
Note: If you want to gain information about How Far Can a 624×50 Scope See click HERE.
Glue
A very small bead of glue should be placed around the edge of the scope body so that the scope does not rotate again. Toothpicks should be used to push and smear the adhesive out to where you want the scope to stay put.
Note: If you want to know What Scope Rings Fit Ruger American Rifle click HERE.
Reassemble
You’ve done everything right! Now you’re ready to aim. Your scope is tight and secure, and you’ve double-checked that the reticle is aligned properly. You’re ready to shoot.
Tips For Maintaining Your Scope Crosshair
Use a small piece of tape (or paper) to remove the crosshair. Heat the adhesive until it melts. Remove the crosshair with tape or paper.
Use a small flathead screwdriver or blade to pry out any remaining pieces of glue. Then apply some new adhesive in this region, and reattach the scope crosshair. Use an extra layer of tape to ensure a good seal
Cleaning your rifle scope is a good way to make sure you can use it without any problems. Before putting new crosshairs onto your scope, make sure the entire lens is clean and dry. You should also check if there are any scratches or dirt on your scope. If there are, then you need to remove those first. Then, put new crosshairs on the scope.
Note: If you want to know When Was the ACOG Scope Invented click HERE.
How to Fix Crooked Crosshairs on a Scope?
Conclusion
Crosshairs should always be adjusted by professionals. Otherwise, you may end up shooting yourself or someone else.
If you want to gain complete information about scopes click HERE.
